The temperature of the CR-10S heat bed did not rise.
To be precise, it only rises to 40 ° C. Is a partial disconnection of the heater wire?
I used it quite a bit. I feel like I output more than 15 kg.
It was selling replacement parts to Amazon, but it seems that you have to solder the connector yourself.
However, I found a heat bed with a connector on eBay.
https://rover.ebay.com/rover/1/711-53200-19255-0/1?mpre=https%3A%2F%2Fwww.ebay.com%2Fitm%2F300mmx300mm-PCB-Aluminium-Heated-Bed-Plate-For-Creality-Cr-10-Cr-10s-3D-Printer%2F382879782145%3F_trkparms%3Daid%253D555018%2526algo%253DPL.SIM%2526ao%253D1%2526asc%253D57475%2526meid%253D652aa2c3f1c74dd3be7b2dbb124286be%2526pid%253D100005%2526rk%253D5%2526rkt%253D7%2526sd%253D401677947965%2526itm%253D382879782145%26_trksid%3Dp2047675.c100005.m1851&campid=5338483311&toolid=20008
Comments